What are the utmost techniques to fix the broken parts of the shutter?

Installation of shutter repair is becoming a trend these days. Everyone is installing the roller shutter for doubling the security of the house, workplace etc. There are different types of roller shutters available in the market. You can choose the roller shutter according to the need of the place. Once installed doesn’t mean you will not take care of it. Roller shutter does need service and shutter repair by an expert.

What is the method of fixing the louver pin?

The louver pins are the one which helps the louver shutter connected to the shutter panel. You will come to know when the louver pin is damaged. You want to know-how instead of attached horizontally the louver is damaged and swinging from the frame.

You can fix it by taking out the louver pin from both the louver. After taking out pins from both the sides put another pin into the side piece of the shutter which is also known as a stile. Then pull down the pin until it is gone into the old pinhole. Now your shutter is ready for the up and down movement.

What is the method of fixing a shutter magnet?

If your roller shutter stays shut instead of going up then it might be a broken louver magnet problem. Not only the magnet is broken but the plastic housing of the magnet that normally sits on your window frame is broken. While operating the shutter, if the magnet is connected to the shutter stile while it swings open that means you have broken the magnet casing.

Do not worry you can fix the problem. All you need to do is with the help of a screwdriver remove the screws from the broken magnet housing from your frame. Then detach the broken casing and magnet. With the help of a screwdriver , put the new magnet inside the holes. But be careful while doing make sure to screw the magnet house tightly so that it won’t mover here and there.

What is the method of fixing a tilt rod staple?

Fixing a tilt rod staple will be the difficult task as compared to fixing the magnet and louver pin. All you need to do is bent needle -nose pliers, wood glue, etc. Starting with detaching of any remains of the broken staple and guide its legs into the existing staple holes. If you are finding the holes are too big then before inserting the staple in use the wood to fill the hole.

Here is the utmost technique to fix the broken parts of the shutter. If still, you are finding difficulty in fixing it then you need expert advice.